Turbo Boost System Leakage Tester Cooling System Hose Leak Engine Leak Tester

Description: MRCARTOOL Turbo System Charger Air Pressure Leakage Tester Kit will help you charge the turbo system with a low pressure of regulated workshop mains air supply, check and locate the leakage on the turbo systems on various vehicles, it works on most turbo systems of cars & light trucks, and also cooling system hoses,save your valuable time and money. Features:➤1.Designed to charge the turbo system with a low pressure of regulated workshop air to show the presence of leaks within the system.Can also be used on cooling systems pipe.➤2.Helps locate air leaks in turbo system components by plugging the output side of the turbo and the intake inlet.Pressure loss can be located easily by hand or leakage spray.➤3.4 pairs of stepped adapters to fit most turbo systems on cars and light trucks. Adapters range from 1-3/8''(35mm) to 3-1/2''(90mm)➤4.Pressure gauge with shut off valve & regulator to help prevent over pressurisation.➤5.Can also be used on some cooling system hoses. 4 Pairs of Stepped Adapters:• 35, 40, 45 mm (1.38'', 1.57'', 1.77'')• 50, 55, 60 mm (1.97'', 2.17'', 2.36'')• 65, 70, 75 mm (2.56'', 2.76'', 2.95'')• 80, 85, 90 mm (3.15'', 3.35'', 3.54''). Kind Reminder:Refer to manufacturer's manual relating to the maximum air pressure of the turbo or other system being tested. Over pressurisation may damage system components! For example:The maximum pressure in most vehicle turbo systems is approximately 15psi (1bar) up to 25psi (1.7bar)A vehicle coolant system is typically rated at 15psi Operation Stpes:1.Select the correct adapter by first measuring the hose diameter.2.Set regulator of tester to 5psi to check for large leaks with valve, open (operating handle inline with the hose axis). And with the air coupling disconnected.3.Select correct size adapters and place in hoses,then tighten the clamp4.Connect the air coupling to check for leaks at the pre-set (5psi). If a leak is identified audibly, it indicates that the system has a fault resulting in loss of pressure.5.If no leaks are evident, regulate pressure to 10psi.6.If no leaks are evident, regulate pressure to a maximum of 15psi or to the manufacturer’s maximum pressure and retest.7.If the gauge pointer remains stationary for one minute it will indicate that system works good.8.Release the pressure in the system by rotating the ball valve lever to align with hose axis.9.Disconnect the quick coupler, clean and return all items to carry case. Package:1PCS Pressure Gauge with a shut off ball valve, a pressure release valve, air coupling and air inlet8PCS Plastic Stepped Adapters(35mm - 90mm)

Price: 69.99 USD

Location: Bordentown, New Jersey

End Time: 2024-12-13T10:57:24.000Z

Shipping Cost: 0 USD